As electronic products become more compact and complex, printed circuit board (PCB) designs have evolved from single-layer boards to double-sided and high-density multilayer boards. This progression places greater demands on hole fabrication: hole diameters are shrinking, and the spacing between holes is tightening. In many board shops, epoxy resin-based composite materials are common, and holes are classified by diameter: small holes are those below 0.6 mm, while microvias are below 0.3 mm. This article focuses on mechanical drilling, the primary method for creating these small holes.
Understanding axial force and cutting torque
To maintain high processing efficiency and hole quality while reducing defect rates, mechanical drilling must account for two key factors: axial force and cutting torque. These forces can directly or indirectly affect hole quality. As feed rate and cutting layer thickness increase, axial force and torque rise, which in turn raises cutting speed. A higher cutting speed means more fibers are cut per unit time, accelerating tool wear. Consequently, drill bit life varies with hole size, and operators must know their equipment's performance and replace bits promptly. This is a major reason why small-hole processing carries higher costs.
Within axial force, the static component (FS) affects the cutting action of the chisel edge, while the dynamic component (FD) mainly influences the main cutting edge. FD has a greater impact on surface roughness than FS. Typically, when the pre-drilled hole diameter is below 0.4 mm, FS decreases sharply as hole diameter increases, whereas FD decreases more gradually.
Drill bit wear and lifetime
PCB drill bit wear depends on cutting speed, feed rate, and hole size. The ratio of drill radius to glass fiber width strongly affects tool life: a larger ratio means the tool cuts a wider bundle of fibers, increasing wear. In practice, a 0.3 mm drill bit can drill approximately 3,000 holes. Larger drill bits generally achieve fewer holes before replacement.
To prevent common drilling defects such as delamination, barrel damage, smearing, and burrs, several measures can be taken. For delamination, place a 2.5 mm thick backup board beneath the copper clad laminate (CCL), and add an aluminum entry sheet on top. The aluminum sheet serves three purposes: it protects the board surface from scratches, dissipates heat generated during drilling, and acts as a buffer and guide to prevent hole misalignment. To reduce burrs, vibratory drilling techniques can be used, along with carbide drill bits that offer good hardness. Tool dimensions and geometry may also need adjustment.
Practical considerations for small-hole drilling
Mechanical drilling remains the workhorse for small holes and microvias, but success depends on managing forces, tool wear, and material behavior. Proper backup and entry materials, appropriate drill bit selection, and timely replacement are essential. As hole sizes continue to shrink, these practices become even more critical for yield and reliability.
What this means for your build
- Design for drillability: Keep hole sizes within your fabricator's comfortable range and avoid unnecessarily small holes that increase cost and risk.
- Specify drill bit life: Discuss with your manufacturer how drill bit wear is managed, especially for microvias, to ensure consistent quality.
- Consider entry and backup materials: These consumables affect hole quality and burr formation; ensure your fabricator uses appropriate materials for your stackup.
- Plan for inspection: Small holes and microvias require robust inspection methods such as cross-section analysis to verify plating thickness in the barrel and detect defects.
- Communicate with your fabricator: Early DFM discussions about hole sizes, aspect ratios, and material choices can prevent costly issues during production.
Source: compiled from public web sources.